Antari DNG-100 User Manual download pdf (Page 4)

Setup

 Remove all packing materials from shipping box. Check that all foam and plastic padding is

removed, especially in the nozzle area.

 Attach power cord to rear of fog cooler.

 Place the fog cooler’s intake within six inches (15 cm) of a fog machine’s output.

 Plug power cord into a grounded electrical outlet. Turn power switch on rear of unit to ”ON”

position.

 Waiting time for cooling is approximately two minutes.

Operation

 ANTARI Fog Cooler’s output volume is determined by the output volume of the fog machine to

which it is attached.

 Your ANTARI dealer has the hoses and adapters required for an optimal installation of the fog

cooler. See the two illustrations below:

In the first example, a fog conducting hose (FT-10) is attached to a fog machine’s output nozzle via an

adapter (FTA-1 or FTA-2) and then connected to an adapter (FTA-10) attached to the fog cooler’s

intake.

In the second example, substitute the guide plate (FTA-12) with a fog conducting hose (FT-10) that

attaches to the front of the fog cooler via an adapter (FTA-11). This configuration allows the fog

cooler’s output to be guided to a desired area without being affected by air currents generated by

movement, wind, fans or air conditioners.

During operation, if you experience mechanical noise or no output, unplug immediately. Check power

connections and fog machine operation. Wait three minutes and then plug the unit in again. After

plugging the unit in and turning it on, wait for two minutes. If the problem persists, discontinue

operation and return the machine to your ANTARI dealer.

Maintenance

Clean the water carrier regularly to avoid overflowing.

Clean with a damp cloth.

Store in a dry place.

Save these instructions

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Antari DNG-100 User Manual Page 4