Antari DNG-100 User Manual download pdf (Page 3)

2. Unpacking & Inspection

Open the shipping carton and verify that all equipment necessary to operate the system has arrived intact.

The shipping carton should contain the following items:

1. One unit DNG-200 Machine

2. One unit of D-20 LCD controller (installed in the machine already)

3. Two power cords for connecting to Neutrik Powercon connector.

4. Three meters of fog conducting hose.

5. One user’s manual

( item 3-5 placed in the storage box on the top of the machine)

6. One water collection tray (installed in the machine already)

7. Three meters of 6mm PU tube

3. Procedures of Installation

3-1. The wheels at the bottom of DNG-200 help to move the machine, wheel xing mechanisms are

located at the diagonal line. Position the machine at a spot, press down the xing mechanism to

prevent it from moving. To move the machine, press the opposite side of the xing mechanism to

release it. Please note that the machine is not allowed to place on a slope due to its big size.

( refer to the gure 1.)

3-2. Please aim the key on the Powercon terminal of the power cord to the slot of the connector on the

machine, plug in and turn about 10 degrees clockwise until the power cord is completely xed. Two

power cords shall be plugged to the machine in the same fashion. The upper power cord is for fog

generator and the bottom one is for the compressor. ( refer to the gure 2&3)

◄ Figure 1

◄ Figure 2 ◄ Figure 3

DNG-200 User Manual

1 2 3 4 5 6 7 8 ... 15 16

No comments

Antari DNG-100 User Manual Page 3